IntegraRack IR AnchorSpike™ Mounting Kit (10-pack or 22-pack) for BallastRack
The IR AnchorSpike™ Kit includes (10) 3/8 x 30″ hollow barbed aluminum spikes and a two-part epoxy to anchor the spikes into the ground with unbelievable amounts of strength. Each IR AnchorSpike is rated for up to 1,000 pounds of uplift (see IntegraRack’s Stamped Engineering & Datasheets) and the base tube of each BallastRack frame is designed to clamp around and bite into each IR AnchorSpike, allowing for easy leveling of the system.
Notice
- One AnchorSpike must be tested at installation site to ensure it can withstand 1,000 lbs of uplift
- Kit is designed to mount five BallastRack frames or one row of four solar panels
- Epoxy takes up to 8-10 hours to harden and 24 hours to fully cure (@ 70°F). Installation can be completed once epoxy has hardened
- Not intended for use with other IntegraRack mounting kits
No Building Permit Required
When installing the BallastRack system with the AnchorSpike mounting kit, a building permit is typically not required (see documentation)
Included In Kit
- (10) IR AnchorSpikes
- (1) Epoxy A
- (1) Epoxy B
- (1) 32oz Mixing Cup
- (1) Stirring Stick
- (1) 3oz Pouring Cup
- (1) Funnel
- (1) High Quality Open-Ended Ratchet Wrench
Recommended Tools
- SDS Hammer Drill
- 3/4 In. x 30 In. SDS-Max Speed-X Carbide Rotary Hammer Bit for Concrete Drilling
Installation Time: Under 10 Minutes Per Module
PRODUCT RESOURCES
